Other accessories

Accessories other than print heads are available, some of which take a tool position.

Tool Position Accessories

The following accessories are loaded into tool positions on the yoke:

Lasers

See Lasers.

Spindle Tools

• 

  ST1

• 

  ST3

The ST1 is intended for light drilling and routing operations (especially circuit board work), and provides between 500 and 5,000 RMP (depending on load) to a 1/8" chuck. 12VDC, 4A, 40W.

The ST3 is intended for light drilling and machining operations (even on brass), and provides between 2,000 and 12,000 RMP (depending on load) to a 1/48" chuck. 48VDC, 8.3A, 400W.

Our Repetrel software can process Gerber and DRL files for the Spindle Tool and/or the Lasers.

Other Tool Position Accessories

The following accessories each take up a tool position while performing more ancillary functions:

• The Mic200 (200x Microscope) provides magnification and capture of images and video.
• The Quiet Storm fan provides additional cooling.
• The Tramming Tool, provided with every printer, is used to level the build surface.
• The Precision Tool Setter! See https://www.youtube.com/watch?v=rW7h9z5DW5A

Non-Tool Position Accessories

The following accessories are not loaded into tool positions on the yoke:

• The HTC - Enclosure Heater with Temperature Control is avialable in 120 and 240 VAC versions. Spec Sheet
• The Feed Chamber Cooling Fan mounts on Hot Flow heads to provide additional cooling to the feed chamber. This is desirable with low temperature filaments like PLA.
• The Printer Support Kit is included with every printer, and includes a build plate, blue tape, and a variety of handy tools like tweezers, razors, and a spatula.
• The SDK - Software Developer's Kit provides hardware, software, and the source code for developing your own firmware for your own compatible heads.
• The LTK - Luer Tip Kit provides an EMO to Luer adapter and a variety of luer lock needles.
• The Syringe Kit provides syringes in quantity.
• The Drill Bit Kit provides an assortment of drilling bits and end mills for the Spindle Tool.
• The Filament Kit provides a variety of filaments to get you started with your printer.