Difference between revisions of "Gcode Basics"

From Hyrel3D
Jump to navigation Jump to search
(Redirected page to Gcode)
 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
[[Category:Gcode]]
#REDIRECT [[Gcode]]
{| align="right"
| __TOC__
|}
 
== Start Gcode ==
 
This code should be at the beginning of every Gcode file:
 
<nowiki>
M757 S[nozzle_diameter] ;set layer/path width
M729 S3 ;set 16 step mode
M758 S0.095 ;set steps/nL
M734 F60 ;set error reporting interval for redundant errors to every 60 seconds
;--------------------</nowiki>
 
== End Gcode ==
 
This code should be at the end of every Gcode file:
 
<nowiki>
;--------------------
;M721 ;unprime
M103 ;stop extrusion
M104 T10 S0 ;turn off all extruders
M140 S0 ;turn off hotbed</nowiki>
 
== Layer Changes ==
 
Please also note, that if you want to take advantage of several new features regarding
layer change options, ( I.E. pause at end of layer, take picture, etc)
you will want to add the M790 to the layer change G-Code as well:
 
<nowiki>
M790 ;announce new layer</nowiki>
 
== Everything ==
 
Here is code that should be in EVERY recipe:
 
<nowiki>
;now we set up for any build offsets that we may want
G21 ; use millimeters
G90 ; absolute coordinates
G0 Z5 ; lift head to avoid collisions
G28 X0 Y0 ;always home before starting a build home X and Y
G0 X0 Y0 ; move to desired origin, necessary if you want a negative offset
G92 X0 Y0 ; reset origin:to new  X and Y, it is legal to add values to x an y, I.e. X30 Y40 will
;set the current location to X30 an Y40
M83 ; relative extruder coordinates
 
;set up Head Flow characteristics
M6 T10 ; select all heads on yoke 1
;M227 ; enable unprime/prime on non printing moves
M221 S1.0 ; set fudge factor for extruder to 1.0
M756 S[first_layer_height] ; set first layer thickness
M757 S[nozzle_diameter] ; set layer/path width
M729 S3  ; set 16 step mode
;set the pulses per unit volume, this is different depending on extruder type
;and material size, I.e if the 1.75mm filament is really 1.65, you can adjust this number
;Or the Fudge factor M221 to get the correct amount of material.
M758 S0.095  ; set steps/nL</nowiki>
 
Typical S values for M758:
<nowiki>
MK-1    ABS 1.75mm    .09-.12
EMO-25  Plasticine    .06</nowiki>

Latest revision as of 13:36, 23 June 2020

Redirect to:

Retrieved from "https://hyrel3d.in/wiki/index.php?title=Gcode_Basics&oldid=4846"