Installation Overview

NOTE: Our environment is intended to be run by the HYREL user in the operating system, with FULL ADMINISTRATOR rights and privileges, on a windows device running in American English as the native language. If you vary from this, results may be unpredictable.

Please note that version 4 and above require a license key to operate - see Licensing for details.

Please note that you should ensure that your ST-Link is working before you attempt this upgrade.

Please note that if you cannot perform the upgrade yourself, we charge a $100 service fee to help.

NOTE: If you are installing on another device to control your printer from a computer other than the tablet we ship with, PLEASE follow the instructions at USB.

New Installer!

Our new installer at will perform steps 1-5 for you. If you use this, please follow up with step 6, flashing Firmware.

Overview

A full Repetrel install may be done on any Windows 10 computer, and includes the following:

WinRAR

We compress our files with WinRAR. Get it from our WinRAR page.

Ecosystem Apps

This suite of software enables many of the features we use. Get it from our Ecosystem_Apps page.

Adobe Reader

We use Adobe Reader to display manuals within Repetrel. Get it from our Adobe_Reader page.

Repetrel

This is the software (and firmware) that runs our printers.

Our latest Version 4 release is recommended for all users. Repetrel v4

Drivers

Our required OS drivers and C++ redistributables can be downloaded from our Drivers page.

Firmware

The Firmware comes with the Repetrel download, but the instructions can be found on our Firmware page.

Settings

Repetrel must be configured for your device and environment; please follow the instructions on our Settings page.

Recipes

Recipes for Slic3r, Cura, Simplify 3D and Prusa Slicer can be found on our Recipes page.

Versions

What versions am I on right now?

Repetrel Software and Motion Controller Firmware:

Head/Bed Firmware:

Version 3 and earlier:

Version 4: