Difference between revisions of "Installing Elsewhere"
| Line 12: | Line 12: | ||
# Install [https://www.rarlab.com/download.htm WinRAR] to uncompress our files. | # Install [https://www.rarlab.com/download.htm WinRAR] to uncompress our files. | ||
# Install [[New_Install|Repetrel]] - all steps, in order! | # Install [[New_Install|Repetrel]] - ''all steps, in order!'' | ||
# Install [http://www.hyrel3d.net/downloads/updater/EcosystemApps.exe Ecosystem Apps]. | # Install [http://www.hyrel3d.net/downloads/updater/EcosystemApps.exe Ecosystem Apps]. | ||
# Navigate to C:\EcosystemApps\Slic3r\slic3r.exe and execute it from the windows browser BEFORE LAUNCHING Repetrel. | # Navigate to C:\EcosystemApps\Slic3r\slic3r.exe and execute it from the windows browser BEFORE LAUNCHING Repetrel. | ||
Revision as of 20:36, 1 March 2019
Installing on Another Computer
Note that all Hydra and EHR models have the new tablet interface boards, and no jumpers are required.
We run versions of Repetrel on Windows 7, 8 and 10 on both Intel and AMD processors; however, you may not be able to run the printer from every unique environment possible. Please know that we cannot help troubleshoot every unique environment - this is why we include a full Tablet PC with each printer. These instructions work for most external installs:
- Install WinRAR to uncompress our files.
- Install Repetrel - all steps, in order!
- Install Ecosystem Apps.
- Navigate to C:\EcosystemApps\Slic3r\slic3r.exe and execute it from the windows browser BEFORE LAUNCHING Repetrel.
- Go to File > Preferences and set the Mode to Expert, check all four boxes, and click OK. Then close Slic3r and launch Repetrel.
- Install the latest Adobe Acrobat Reader.
- Launch Repetrel!
My 30M/ESR Shipped with a Tablet
1. Don't worry about ever powering up the tablet - you can remove it. We just want the 3.3v, 5v and 12v power and USB connectivity to the spine and beyond.
2. Install the software as shown at Repetrel above, and Ecosystem Apps below.
3. Install the drivers as shown at Drivers above.
4. Units shipped before mid 2017 have the first tablet interface board, and need to have jumpers in place to connect the USB port. Units shipped after mid 2017 have the new tablet interface board, and there is no need for jumpers. If you have the OLD one, unplug the cables for the tablet USB connectivity and install PC Jumpers as shown:
See the video.
5. Run a USB A to B cable from your PC to the USB-B port on the left side of the Printer:
My 30M/ESR Shipped with a Motherboard
1. Don't worry about ever powering up the motherboard. We just want the 3.3v, 5v and 12v power to the spine and beyond.
2. Install the software as shown at Repetrel and Ecosystem Apps.
3. Install the drivers as shown at Drivers above.
4. Run a USB to MiniUSB cable from your PC to the MiniUSB port on the right side of the Spine:
5. Run a USB to MiniUSB cable from your PC to the MiniUSB port on the top, inside of the Spine:
