Difference between revisions of "Published Papers"

From Hyrel3D
Jump to navigation Jump to search
Line 229: Line 229:


* [https://pubs.acs.org/doi/abs/10.1021/acs.biomac.1c00105 3D-Printed Enzyme-Embedded Plastics] by a team from [https://www.scionresearch.com/ Scion], a Crown Research Institute in New Zealand
* [https://pubs.acs.org/doi/abs/10.1021/acs.biomac.1c00105 3D-Printed Enzyme-Embedded Plastics] by a team from [https://www.scionresearch.com/ Scion], a Crown Research Institute in New Zealand
* [https://link.springer.com/article/10.1007/s11837-021-04647-5 Novel Architected Material for Cardiac Patches] by a team from the [https://engineering.utsa.edu/mechanical/ Department of Mechanical Engineering, University of Texas at San Antonio]


==== Published in 2020 ====
==== Published in 2020 ====

Revision as of 11:44, 26 April 2021

Below is a list of published works citing Hyrel equipment.

241 documents as of 23 April 2021.

Non-Traditional Manufacturing

Including Antennas, Sensors, Inductors, and Circuits; Combined Manufacturing Techniques; Electro-Spinning or Electro-Melt-Spinning; also printing with Embedded Fibers

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Published in 2016

Published in 2015

Unheated or Chilled Reservoir Printing (DIW)

Also known as Robocasting or DIW, Direct Ink Writing.

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Published in 2016

Published in 2015

Published in 2014

Heated Reservoir Printing (MEW)

Also known as MEW, or Melt Electro-Writing.

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Filament Printing (FFF/FDM)

Also known as FFF or FDM, Fused Filament Fabrication or Fused Deposition Modeling.

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Published in 2016