THIS PAGE IS A PLACHOLDER.

VERSION 3 IS NOT YET AVAILABLE TO THE MASSES.

Contact is if you have an issue with your present install.

Install instructions are essentially the same as for v2, but remember to:

Go to Settings > Printer and load the latest config for your model; and
Flash the Motion Controller with the latest HYREL file (ESR adn 30M), or HYDRA file (EHR and Hydra).

Here are instructions for installing the latest Repetrel software and associated applications, drivers, and environment on a new Windows platform.

This procedure should also be followed to give a complete 3.x install over an existing 2.x install.

If you want to upgrade an existing install, follow these directions:

These steps should each be done in order, and run as administrator.

Repetrel

This installs the current version of Repetrel. Just uncompress the file and place it at C:.

Your path to Repetrel.exe should be:

C:\Repetrel\bin\Repetrel.exe (capitalization may differ).

Step Two installs the following applications and drivers:

Step Three installs the following applications and drivers:

Step Four installs the following applications and drivers: