Licensing

As of version 4, Repetrel will not operate your motion controller (printer) without a license.

We are happy to help you get your motion controller licensed. Contact us at hyrel3d@gmail.com with any questions. Instructions are as follows:

Repetrel

You must have version 4 or above installed to generate a license.

Launch Repetrel v4

Go to the Settings > Printer menu item:

On the Printer Settings screen, go to the 'Hardware Info tab:

If you are not licensed, you should see:

In the Firmware Key field, INVALID-NO_KEY_FOUND message; and

In the Firmware KEY Seed field, a 44 digit SEED, formatted as five groups of eight characters, each separated by an underscore. An example SEED is 2D10C01F_041352A2_3D48DDA4_10005FD1_6112F6EF. Note, the numbers on this page are examples, and will not work on your printer.

You will get this number to us - preferably, we will get you your license during a live support session; alternately, you can email it to us. You can copy the SEED from the screen, or click the Seed>USB button, which will write it to a text file.

We will then generate a license FOR YOUR UNIT, and get it back to you. This will be a 32 digit license KEY, formatted as two groups of 15 characters, separated by two underscores. An example KEY is d5gh7eAsTdr71f5__k8JEz5j9df984KD. Note, the numbers on this page are examples, and will not work on your printer.

If we do this live, we will apply it; if via email, you should complete the following steps:

Go back to the Printer Settings screen and paste the LICENSE (with no extra spaces) in the Firmware KEY field, and then click Flash KEY: