Filaments

Some settings for the MK1-Type heads (like temperature, prime/unprime values) will vary, depending on what material you are printing with. Nozzle diameter should accurately reflect what nozzle you have loaded (0.5mm is default) AND what path width you sliced for. Having said that, here are our default shipping settings:

Settings	MK1-250, MK2-250	MK1-450 (formerly -350 or -400)	MK1-850*	MK1-1250*
Material
Type	(any)	(any)	(any)	(any)
Color	(any)	(any)	(any)	(any)
Nozzle	0.500	0.500	0.500	0.500
Layer	(any)	(any)	(any)	(any)
Temp Info
Print Temp	240	410	800	1200
Power Factor	100	100	100	100
Minimum	(any)	(any)	(any)	(any)
Maximum	(any)	(any)	(any)	(any)
Overrides
Pulses	0.78	0.78	0.78	0.78
Feed Rate %	1.000	1.000	1.000	1.000
Prime Please note that Prime values will vary greatly from those shown, depending on the compressibility of your material.
Steps	250	250	250	250
Rate	10,000	10,000	10,000	10,000
Dwell Time (ms)	50	50	50	50
Before Tool Change	1	1	1	1
Unprime Please note that Unprime values will vary greatly from those shown, depending on the compressibility of your material.
Steps	250	250	250	250
Rate	10,000	10,000	10,000	10,000
Dwell Time (ms)	60	60	60	60
After Tool Change	1	1	1	1
Offsets
Clone Head	Off	Off	Off	Off
X	0,000	0,000	0,000	0,000
Y	0,000	0,000	0,000	0,000
Z	0,000	0,000	0,000	0,000
Head Info
Model	250	350	850	1250
RTD Type	1 Meg	1 Meg	1 Meg	1 Meg
Motor Current	High	High	High	High
Step Mode	Sixteenth	Sixteenth	Sixteenth	Sixteenth
*In development.