Emulsifiables

From Hyrel3D
Revision as of 14:38, 8 December 2015 by Davo (talk | contribs)
Jump to navigation Jump to search

EMO-Type heads are for printing as follows:

  • With pastes, gels, emulsifiables or waxes.
  • At room or elevated temperatures.
  • With or without UV Crosslining.
  • With Hyrel Nozzles (1.5mm, 2mm) or Luer Tips.

These include the following:

EMO-Type Head Comparison
Model EMO-25 COD-25 VOL-25 VCD-25 KRA-15 KCD-15
Max Temp Ambient Ambient 100°C 100°C 150°C 150°C
UV Crosslinking no yes no yes no yes

As of 16 Nov, the latest firmware is 32V, included with Repetrel 2.828.

Some settings for the EMO-Type heads (like temperature, prime/unprime values) will vary, depending on what material you are printing with. Nozzle diameter should accurately reflect what nozzle you have loaded (1.6mm is default) AND what path width you sliced for. Temperature commands will be ignored by heads with no temperature control. Having said that, here are our default shipping settings:

Settings: 19:1 Ratio: 27:1 Ratio: 51:1 Ratio: 100:1 Ratio:
Material
Type (any) (any) (any) (any)
Color (any) (any) (any) (any)
Nozzle 1.600 1.600 1.600 1.600
Layer (any) (any) (any) (any)
Temp Info
Print Temp 30 30 30 30
Power Factor 100 100 100 100
Minimum (any) (any) (any) (any)
Maximum (any) (any) (any) (any)
Overrides
Pulses 1.600 2.300 4.700 8.750
Feed Rate % 1.000 1.000 1.000 1.000
Prime
Steps 500 700 900 2000
Rate 10,000 10,000 10,000 10,000
Dwell Time (ms) 100 100 110 120
Before Tool Change 1 1 1 1
Unprime
Steps 400 550 750 1600
Rate 10,000 10,000 10,000 10,000
Dwell Time (ms) 100 100 100 110
After Tool Change 1 1 1 1
Offsets
Clone Head Off Off Off Off
X 0,000 0,000 0,000 0,000
Y 0,000 0,000 0,000 0,000
Z 0,000 0,000 0,000 0,000
Head Info
Model (varies) (varies) (varies) (varies)
RTD Type 1 Meg 1 Meg 1 Meg 1 Meg
Motor Current High High High High
Step Mode Sixteenth Sixteenth Sixteenth Sixteenth