Licensing

As of version 4, Repetrel will not operate your motion controller (printer) without a license.

We are happy to help you get your motion controller licensed. Contact us at hyrel3d@gmail.com with any questions. Instructions are as follows:

Repetrel

You must have version 4 or above installed to generate a license.

Launch Repetrel v4

Go to the Settings > Printer menu item:

On the Printer Settings screen, go to the 'Hardware Info tab:

If you are not licensed, you should see:

In the Firmware Key field, INVALID-NO_KEY_FOUND message; and

In the Firmware KEY Seed field, a 44 digit SEED, which is five groups of eight characters, each separated by an underscore. In the screenshot above, my SEED is 2D10C01F_041352A2_3D48DDA4_10005FD1_6112F6EF. Note, the numbers on this page will ONLY work on the printer I used for the screenshots. :)