Filaments

From Hyrel3D
Revision as of 18:43, 19 January 2016 by Davo (talk | contribs)
Jump to navigation Jump to search

Some settings for the MK1-Type heads (like temperature, prime/unprime values) will vary, depending on what material you are printing with. Nozzle diameter should accurately reflect what nozzle you have loaded (0.5mm is default) AND what path width you sliced for. Having said that, here are our default shipping settings:

Settings MK1-250, MK2-250 MK1-450
(formerly -350 or -400)
MK1-850* MK1-1250*
Material
Type (any) (any) (any) (any)
Color (any) (any) (any) (any)
Nozzle 0.500 0.500 0.500 0.500
Layer (any) (any) (any) (any)
Temp Info
Print Temp 240 410 800 1200
Power Factor 100 100 100 100
Minimum (any) (any) (any) (any)
Maximum (any) (any) (any) (any)
Overrides
Pulses 0.78 0.78 0.78 0.78
Feed Rate % 1.000 1.000 1.000 1.000
Prime
Please note that Prime values will vary greatly from those shown, depending on the compressibility of your material.
Steps 250 250 250 250
Rate 10,000 10,000 10,000 10,000
Dwell Time (ms) 50 50 50 50
Before Tool Change 1 1 1 1
Unprime
Please note that Unprime values will vary greatly from those shown, depending on the compressibility of your material.
Steps 250 250 250 250
Rate 10,000 10,000 10,000 10,000
Dwell Time (ms) 60 60 60 60
After Tool Change 1 1 1 1
Offsets
Clone Head Off Off Off Off
X 0,000 0,000 0,000 0,000
Y 0,000 0,000 0,000 0,000
Z 0,000 0,000 0,000 0,000
Head Info
Model 250 350 850 1250
RTD Type 1 Meg 1 Meg 1 Meg 1 Meg
Motor Current High High High High
Step Mode Sixteenth Sixteenth Sixteenth Sixteenth
*In development.