Filament Heads
Revision as of 17:56, 17 August 2016 by Davo (talk | contribs) (Created page with "Category:Hardware Category:Hot_Flow {| align="right" | __TOC__ |} Hot Flow is our term for filament-based materials which are deposited at over 150°C, depending on ...")
Hot Flow is our term for filament-based materials which are deposited at over 150°C, depending on the head.
Note that at present, our Hot Flow heads work with 1.75mm filament (actually, 1.6mm to 1.9mm), but not 3mm filament.
Materials for Warm Flow
The following materials can be printed from Hot Flow heads.
- ABS (Acrylonitrile Butadiene Styrene)
- Flame Retardant ABS
- ABS - PC Alloy
- Conductive ABS
- BendLay
- Flex 45
- HIPS (High-Impact PolyStyrene)
- LayBrick
- LayWoo-d3
- MoldLay
- Ninjaflex
- Nylon
- Taulman 618, 645, 910
- PC (PolyCarbnoate)
- PEEK (PolyEther Ether Ketone)
- PET (PolyEthylene Terephthalate)
- PETG PolyEthylene Terephthalate Glycol-modified)
- PLA (Polylactic acid)
- EcoFlex PLA
- Conductive PLA
- SS PLA (Stainless Steel infused)
- PlastInk_Rubber
- PP (PolyPropylene)
- PVA (PolyVinyl Alcohol)
- T-Glase
Heads for Hot Flow
Hot Flow is available through the following heads:
The following table compares the properties of the various Hot Flow heads:
| Head | Min Temp | Max Temp | Filament | Nozzles |
|---|---|---|---|---|
| MK1-250 | 150°C | 250°C | 1.75mm | 0.50mm Standard 0.35mm, 0.75mm, 1.0mm Optional |
| MK2-250 | 150°C | 250°C | 1.75mm | 0.50mm Standard 0.35mm, 0.75mm, 1.0mm Optional |
| [[MK1-450] | 250°C | 450°C* | 1.75mm | 0.50mm Standard 0.35mm, 0.75mm, 1.0mm Optional |
| *Note, the MK1-450 should either be used in the 250-350°C range, or the 350-450°C range. | ||||