Emulsifiables

EMO-Type heads are for printing as follows:

• With pastes, gels, emulsifiables or waxes.
• At room or elevated temperatures.
• With or without UV Crosslining.
• With Hyrel Nozzles (1.5mm, 2mm) or Luer Tips.

These include the following:

EMO-Type Head Comparison

Model	EMO-25	COD-25	VOL-25	VCD-25	KRA-15	KCD-15
Max Temp	Ambient	Ambient	100°C	100°C	150°C	150°C
UV Crosslinking	no	yes	no	yes	no	yes

As of 16 Nov, the latest firmware is 32V, included with Repetrel 2.828.

Some settings for the EMO-Type heads (like temperature, prime/unprime values) will vary, depending on what material you are printing with. Nozzle diameter should accurately reflect what nozzle you have loaded (1.6mm is default) AND what path width you sliced for. Temperature commands will be ignored by heads with no temperature control. Having said that, here are our default shipping settings:

Settings:	19:1 Ratio:	27:1 Ratio:	51:1 Ratio:	100:1 Ratio:
Material
Type	(any)	(any)	(any)	(any)
Color	(any)	(any)	(any)	(any)
Nozzle	1.600	1.600	1.600	1.600
Layer	(any)	(any)	(any)	(any)
Temp Info
Print Temp	30	30	30	30
Power Factor	100	100	100	100
Minimum	(any)	(any)	(any)	(any)
Maximum	(any)	(any)	(any)	(any)
Overrides
Pulses	1.600	2.300	4.700	8.750
Feed Rate %	1.000	1.000	1.000	1.000
Prime
Steps	500	700	900	2000
Rate	10,000	10,000	10,000	10,000
Dwell Time (ms)	100	100	110	120
Before Tool Change	1	1	1	1
Unprime
Steps	400	550	750	1600
Rate	10,000	10,000	10,000	10,000
Dwell Time (ms)	100	100	100	110
After Tool Change	1	1	1	1
Offsets
Clone Head	Off	Off	Off	Off
X	0,000	0,000	0,000	0,000
Y	0,000	0,000	0,000	0,000
Z	0,000	0,000	0,000	0,000
Head Info
Model	(varies)	(varies)	(varies)	(varies)
RTD Type	1 Meg	1 Meg	1 Meg	1 Meg
Motor Current	High	High	High	High
Step Mode	Sixteenth	Sixteenth	Sixteenth	Sixteenth