Lasers

From Hyrel3D
Revision as of 11:03, 17 August 2020 by Davo (talk | contribs) (→‎CO2 Lasers)
Jump to navigation Jump to search

Lasers: Exciting!

Also, dangerous.

Only safety-conscious adults with proper safeguards should operate lasers of any kind.

CO2 Lasers

LI40.jpg

Hyrel offers a 40w CO2 laser on some of our Hydra models.

We recommend at least 500 cfm of exhaust while lasering.

Hyrel Specific

Laser Alignment

Hyrel CO2 Laser Alignment Video.

Below are great videos about laser alignment in very similar setups:

  1. RDWorks
  2. ThunderLaser
  3. BossLaser
  4. MakeTech

Informational Videos

Below are links to some VERY helpful videos from a gentleman named Russ, who purchased a laser engraver very similar to ours. In these videos, he shares his experiences, advice, and safety tips. While some of what Russ explains does not apply to using lasers on Hyrel equipment, much of it does. Please watch all these videos, even if you don't feel you need the information. Safety first!

  1. Introduction to Laser Cutting
  2. Laser Theory and Safety Issues
  3. Software (n/a for Hyrel users)
  4. Initial Setup and Powerup
  5. Test Prints
  6. Focal Distance and Power Analysis
  7. Modifications and Recommendations from a Year of Use

Diode Lasers

LA5-6.jpg

While less powerful than CO2 lasers, diode lasers are still dangerous, and the same safety precautions apply.

Hyrel offers diode lasers in several configurations:

More videos about the diode lasers: