Difference between revisions of "Published Papers"

From Hyrel3D
Jump to navigation Jump to search
Line 81: Line 81:
==== Published in 2021 ====
==== Published in 2021 ====


*[https://www.sciencedirect.com/science/article/pii/S2590006421000284?via%3Dihub Long-term Stabilized Amorphous Calcium Carbonate—an Ink for Bio-inspired 3D Printing] by a team from the [https://materials.technion.ac.il/en/Research/bio-inspired-surface-engineering-and-biomineralization-lab-2/ Bio-Inspired Surface Engineering and Biomineralization Lab of Technion University]
*[https://aiche.onlinelibrary.wiley.com/doi/abs/10.1002/aic.17412 Direct Ink Write 3D Printing of High Solids Loading Bimodal Distributions of Particles] by a team from [http://gatech.edu Georgia Tech]'s schools of [https://www.mse.gatech.edu/ School of Material Science and Engineering] and [https://chbe.gatech.edu/ School of Chemical and Biomolecular Engineering]
*[https://aiche.onlinelibrary.wiley.com/doi/abs/10.1002/aic.17412 Direct Ink Write 3D Printing of High Solids Loading Bimodal Distributions of Particles] by a team from [http://gatech.edu Georgia Tech]'s schools of [https://www.mse.gatech.edu/ School of Material Science and Engineering] and [https://chbe.gatech.edu/ School of Chemical and Biomolecular Engineering]
*[https://commons.erau.edu/cgi/viewcontent.cgi?article=1628&context=edt Additively Manufactured Dielectric Elastomer Actuators: Development and Performance Enhancement Development and Performance], a thesis submitted for a [https://erau.edu/degrees/phd/aerospace-engineering PhD in Aerospace Engineering at Embry-Riddle Aeronautical University]
*[https://commons.erau.edu/cgi/viewcontent.cgi?article=1628&context=edt Additively Manufactured Dielectric Elastomer Actuators: Development and Performance Enhancement Development and Performance], a thesis submitted for a [https://erau.edu/degrees/phd/aerospace-engineering PhD in Aerospace Engineering at Embry-Riddle Aeronautical University]

Revision as of 19:30, 13 September 2021

Below is a list of published works citing Hyrel equipment.

Count

283 documents as of 10 Sep 2021.

Non-Traditional Manufacturing

Including Antennas, Sensors, Inductors, and Circuits; Combined Manufacturing Techniques; Electro-Spinning or Electro-Melt-Spinning; also printing with Embedded Fibers

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Published in 2016

Published in 2015

Unheated or Chilled Reservoir Printing (DIW)

Also known as Robocasting or DIW, Direct Ink Writing.

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Published in 2016

Published in 2015

Published in 2014

Heated Reservoir Printing (MEW)

Also known as MEW, or Melt Electro-Writing.

Published in 2021

Sweat‑Enhanced Conductivity for Wearables] by a team primarily from Nanyang Technological University, Singapore

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Filament Printing (FFF/FDM)

Also known as FFF or FDM, Fused Filament Fabrication or Fused Deposition Modeling.

Published in 2021

Published in 2020

Published in 2019

Published in 2018

Published in 2017

Published in 2016