Search results

[[Category:Thermoplastics]]

...ed with the GeckoTek EZ-Stik build plates, and now recommend them for most thermoplastics (printing at under 350C; they stick TOO well to PEEK and Ultem).

I personally recommend '''USING the M229 E1 D1''' if you are printing with thermoplastics, as some slicers adjust this E value for thicker lines (or layers). Most thermoplastics do better with a heated chamber, so you would not want to vent (or have a v

...put Variables on the Mechanical Properties of Additively Manufactured PEEK Thermoplastics] by a team from [https://www.etsmtl.ca/en/ets/governance/deans-and-departme ....1007/978-1-0716-0611-7_7#Sec13 Additive Manufacturing Using Melt Extruded Thermoplastics for Tissue Engineering], part of the textbook [https://link.springer.com/bo